Nash Competition Engines

Get it done right the first time and right on time.Nash Engines.

Very helpful even they didn't do the job.They help me with correct Path. I recommend this place any time.

Nash has done several heads for me in the past and most recently (2 years ago) set up my bottom end on a stroker build (2.8 liter 1980s bmw motor).I assembled the motor after the work was done and in the first 25 minutes of operation I developed a hard-core misfire and some very bad noises from the motor. I took it apart and found a valve stuck. This was repaired by nash free of charge even though it turned out to not be their fault, rather the shop I had weld my intercooler piping together (aluminum shaving caught between the valve and guide).Motor was dynoed at 411 wheel/397 torque at 18 psi. I routinely have the thing on the limiter for extended periods of time. Out of paranoia, I pulled the rods caps after losing oil pressure for a split second while drifting. The bearing shells appear as though they were never even installed in an engine after just over 12000 kms. Absolutely fantastic work.

These guys know their stuff....from the most expensive race piece being overhauled and customized to the small inexpensive daily driver this is where you need to start

I had an issue with one bent valve i took there and was repaired very proffessionally above and beyond and at no cost it took at least half hour tks a lot would highly reccomend not only because of the freee ness but of the honesty and quality of work and consideration

These guys Built my marine 535 Big Block, boat runs like a champ. Thanks guys!

Engine built by this shop, bottom end is good, top end is a complete mess, valves are all set at different lengths from 20thou to 60 thou, head doesn't have adjustable rocker arms, shop should have known this, head now breaks rocker arms, valve seals are all crushed and the head bends valves, maybe they can build a good 350 but cant figure out a ford 2.3? not impressed sub par work. called for more info on head and got yeahhhh wasn't that a ford head with a weird cam? yes, yeah that's all we got, been chasing gremlins for awhile now, would give 0 stars if I could

Nash has built all my motors including my viper and a few friends viper motors, highly recommended.

100% They know their stuff

Use Nash for all my machine shop needs, very knowledgeable staff.Keep up the good work guys.